Removes waxes, varnishes, paints and most antifoulings
The coating becomes water soluble (just rinse with water)
Removes up to 8 coats of paint in 1 application
Easy to apply – even on difficult surfaces.
Does not evaporate – does not dry out
WHERE TO USE
On wood (except oak, walnut, parquet and flake), metal (except aluminum), plastic, stone, cement….
Perfect for surfaces that are difficult to remove coatings from or very decorative – horizontal and vertical – doors, gates, barricades….
Recommended for large areas – non-flammable, does not dry out, remains active for a long time.
It does not attack plastic, rubber, synthetic layers or fiberglass.
RECOMMENDATIONS BEFORE APPLICATION
Always test the product in an invisible place.
Wear protective gloves – rubber or nitrile gloves. Use a nylon or synthetic brush.
The time required to remove the coating depends on the number of layers, the type of paint (water-based, oil-based) and ranges from a few minutes to a few hours. From time to time, check that the layers are already properly softened.
The surface should ALWAYS be neutralized with NET-TROL after applying DILUNETT.
APPLICATION
Apply a thick layer of DILUNETT to the surface.
Leave.
When DILUNETT begins to dry, spray with a fine mist of water.
Scrub the surface with a stiff nylon brush or rinse with water using the highest available pressure (max. 60 bar).
The use of hot water makes the task easier.
After removing layers, always neutralize the surface with NET-TROL – immediately after rinsing off the product.
